Unable to surf the entire web because you're stuck behind a restrictive firewall? Then Shadowsocks might be your answer. In this guide, we'll walk you through the steps to use this proxy to connect to our servers using the Mullvad command line interface (CLI) in your operating system's terminal.
Please see our Intro to Shadowsocks guide.
To use this guide, you need
Open the terminal.
Open the command prompt and navigate to C:\Program Files\Mullvad VPN\resources\
This command will configure Mullvad to use Shadowsocks.
mullvad bridge set location any
You can specify the location of the Shadowsocks bridge server by replacing
any with a specific country or city. For example,
mullvad bridge set location us chi will connect you to Chicago in the U.S.
To get a list of all location options and their abbreviations, run the following command.
mullvad bridge list
To specify a specific bridge server, run
mullvad bridge set location us chi us-chi-br-001, in which you specify country, city, and that location's server name which you can find in our list of bridge servers.
Run the following command to connect to our VPN servers using Shadowsocks.
mullvad bridge set state on
mullvad bridge set state off
Run the following command and you will either see "on" or "off".
mullvad bridge get
If you check your status on am.i.mullvad.net while connected, nothing about Shadowsocks or a bridge connection will be mentioned. Only your exit location/server will display.
You can also configure a variety of advanced options, including proxy, IP, and cipher. Run the following command but replace
xxx.xxx.xxx.xxx with the IP address of the Mullvad bridge server you want to use as your entry location.
mullvad bridge set custom shadowsocks xxx.xxx.xxx.xxx